ACP Sheet Metal Design 3

Question 1

Which of these is NOT an unfold rule type in the Inventor Style and Standard Editor?

Accepted Answer

Neutral Spline

Answer

Inventor unfold rules can be Linear (K-factor), Bend Table, or Custom Equation, and there is no Neutral Spline type.

Question 2

Which Cut command option wraps a sketch profile across a bend in the folded model?

Accepted Answer

Cut Across Bend

Answer

Cut Across Bend maps the profile across the bend region so that the cut follows the bent geometry.

Question 3

What is the usual workflow for adding a feature that must span a bend in the folded model?

Accepted Answer

Unfold the bend, add the feature, then Refold

Answer

Unfold temporarily flattens selected bends so features can be added, and Refold restores the folded state with the feature kept.

Question 4

What sketch geometry does the Punch Tool command use to locate punch features?

Accepted Answer

Sketch center points on the face

Answer

The Punch Tool places the iFeature at center points in a sketch on the sheet metal face.

Question 5

Which bend relief shape removes no material and lets the sheet tear at the end of the bend?

Accepted Answer

Tear

Answer

Tear relief rips the material at the bend ends without removing any material.

ACP Autodesk Inventor