Practice Test GeeksACP Autodesk Inventor
← All ACP Flashcard Decks

Frame Generator Flashcards

7 cards from real ACP practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Frame Generator flashcards as text

  1. Which statement about the Miter end treatment is correct?

    Answer: It cuts the selected members along the bisector of their angle, with an optional gap

    Miter splits the angle between two members and can leave a set gap.

  2. Two placed frame members came out mirrored from what you wanted. Which option in the placement or Change dialog flips the profile's orientation?

    Answer: Mirror Frame Member

    Mirror Frame Member flips the cross-section about its orientation axis.

  3. Which Content Center parameter commonly holds a frame member's length and is often used for BOM base quantity?

    Answer: G_L

    Frame Generator members store their length in the G_L parameter, which the BOM can use as base quantity.

  4. You want a vertical post's notch into a horizontal beam to leave a 1 mm clearance. What do you set?

    Answer: An offset value in the Notch dialog

    Notch has an offset that grows the notch cut by a clearance amount.

  5. A designer needs a frame member to run between two points that are not joined by a skeleton line. Which placement mode fits?

    Answer: Insert member between points

    The between-points mode builds a member from a start point to an end point.

  6. Which of these is NOT a Frame Generator command?

    Answer: Bolted Connection

    Bolted Connection is a Design Accelerator generator, not part of Frame Generator.

  7. In the Insert Frame Member dialog, what do the horizontal and vertical offset values do?

    Answer: Move the profile off the skeleton edge within its cross-section plane

    Offsets move the profile sideways from the anchor point, at right angles to the edge.