ACP Tube and Pipe Design Flashcards

In Autodesk Inventor's Tube & Pipe environment, what is the first step to begin routing a new pipe run?

Answer: Use the Create Route command after defining a Tube & Pipe run in the assembly

You must first insert a Tube & Pipe run into the assembly, then use the Create Route command to define the pipe path.

Which Inventor command is used to automatically route a pipe between two connection points along the shortest valid path?

Answer: Auto Route

The Auto Route command calculates and places the shortest valid pipe path between two selected connection points.

What file type stores a Tube & Pipe style definition in Autodesk Inventor?

Answer: .xml

Tube & Pipe styles are stored as XML files within the Tube & Pipe Styles library folder.

When adding fittings to a pipe route in Inventor, which property determines whether a fitting is automatically inserted at a bend?

Answer: Fitting Angle

The Fitting Angle property specifies the angle at which a fitting is automatically placed when a bend is created in the route.

In Inventor's Tube & Pipe module, what does 'nominal diameter' refer to?

Answer: A standardized size designation that approximates the pipe's inner diameter

Nominal diameter is a standardized designation used for pipe sizing that approximates (but may not exactly match) the actual inner diameter.

Which Inventor tool is used to check for collisions between routed pipes and other assembly components?

Answer: Interference Detection

The Interference Detection tool identifies where pipes or fittings overlap or collide with other assembly components.