Practice Test GeeksACP - AutoCAD Certified Professional Practice Test
← All ACP Flashcard Decks

Drawing and Editing Techniques Flashcards

7 cards from real ACP practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Drawing and Editing Techniques flashcards as text

  1. Which function key turns Object Snap Tracking on or off?

    Answer: F11

    F11 toggles Object Snap Tracking, which gives you alignment paths from acquired snap points.

  2. Which object snap lets you set a temporary base point and then enter an offset from it to locate a new point?

    Answer: From

    The From snap sets a temporary reference point and then takes a relative offset such as @2,3.

  3. You need the cursor to snap to 15-degree directions while drawing. Which feature should you configure?

    Answer: Polar tracking increment angle

    Polar tracking guides the cursor along set increment angles, such as 15 degrees.

  4. Which mode limits cursor movement to horizontal and vertical directions only?

    Answer: Ortho mode

    Ortho mode (F8) limits cursor movement to horizontal and vertical directions.

  5. When a hot grip is selected, what does pressing the Spacebar do?

    Answer: Cycles through Stretch, Move, Rotate, Scale, and Mirror

    Pressing Spacebar or Enter cycles through the grip editing modes, starting with Stretch.

  6. While you are building a selection set, how do you remove an object that is already selected?

    Answer: Hold Shift and click it

    Shift+click removes an object from the current selection set.

  7. Which command selects all circles in a drawing with a radius greater than a value you specify?

    Answer: QSELECT

    QSELECT builds a selection set based on object type and property conditions such as radius.