ACP ACP Tube and Pipe Design 1

Question 1

In Autodesk Inventor's Tube & Pipe environment, what is the first step to begin routing a new pipe run?

Accepted Answer

Use the Create Route command after defining a Tube & Pipe run in the assembly

Answer

You must first insert a Tube & Pipe run into the assembly, then use the Create Route command to define the pipe path.

Question 2

Which Inventor command is used to automatically route a pipe between two connection points along the shortest valid path?

Accepted Answer

Auto Route

Answer

The Auto Route command calculates and places the shortest valid pipe path between two selected connection points.

Question 3

What file type stores a Tube & Pipe style definition in Autodesk Inventor?

Accepted Answer

.xml

Answer

Tube & Pipe styles are stored as XML files within the Tube & Pipe Styles library folder.

Question 4

When adding fittings to a pipe route in Inventor, which property determines whether a fitting is automatically inserted at a bend?

Accepted Answer

Fitting Angle

Answer

The Fitting Angle property specifies the angle at which a fitting is automatically placed when a bend is created in the route.

Question 5

In Inventor's Tube & Pipe module, what does 'nominal diameter' refer to?

Accepted Answer

A standardized size designation that approximates the pipe's inner diameter

Answer

Nominal diameter is a standardized designation used for pipe sizing that approximates (but may not exactly match) the actual inner diameter.

ACP Autodesk Inventor