403A Framing 2

Question 1

What is the standard dimensional lumber size for a 2x6 stud after dressing (surfacing)?

Accepted Answer

1-1/2 inches × 5-1/2 inches

Answer

Dimensional lumber is smaller than its nominal size after kiln drying and planing. A nominal 2×6 measures 1-1/2 inches (38 mm) by 5-1/2 inches (140 mm) in actual dimensions.

Question 2

What is the function of blocking installed between floor joists?

Accepted Answer

To prevent joist rotation and distribute concentrated loads

Answer

Blocking (or bridging) between floor joists prevents the joists from twisting or rotating under load and helps distribute concentrated loads to adjacent joists, improving the overall floor system performance.

Question 3

In balloon framing, how do wall studs differ from platform framing?

Accepted Answer

They run continuously from the sill plate to the roof line

Answer

In balloon framing, studs run the full height of the building from the foundation sill plate to the roof. This differs from platform framing where studs are only one storey high.

Question 4

What is the purpose of a trimmer stud (jack stud) in a framed wall opening?

Accepted Answer

To support the header directly and transfer its load to the bottom plate

Answer

Trimmer studs (jack studs) are installed alongside king studs and directly support the header above a door or window opening, transferring the load from the header down to the bottom plate and foundation.

Question 5

What SPF lumber species group is most commonly used in Canadian residential framing?

Accepted Answer

Spruce-Pine-Fir

Answer

Spruce-Pine-Fir (SPF) is the most commonly used species group for framing lumber in Canada due to its availability, workability, and adequate structural properties for residential construction.

Red Seal Carpenter 403A Practice Test

Red Seal Carpenter 403A Practice Test

403A Framing 2