403A Floor, Wall & Roof Framing 3

Question 1

What is the maximum allowable height of an unbraced stud wall using 38×89 mm (2×4) studs according to the NBC?

Accepted Answer

3 000 mm

Answer

The NBC limits 38×89 mm studs in bearing walls to a maximum unsupported height of 3000 mm (approximately 10 feet). Beyond this, larger members (38×140 mm) are required unless the wall is laterally braced.

Question 2

What is the function of a rim joist (band joist) in platform frame construction?

Accepted Answer

To close off the ends of floor joists and provide a nailing surface for wall framing

Answer

The rim joist (band joist) runs perpendicular to the floor joists and is nailed to their ends. It closes off the floor system, ties joist ends together, provides a nailing surface for the bottom plate of the wall above, and helps distribute loads.

Question 3

A wall is framed out of plumb by 12 mm over a height of 2 400 mm. Is this within the NBC allowable tolerance for residential construction?

Accepted Answer

No — the NBC limit is typically 6 mm in 3 000 mm (1 in 500)

Answer

The NBC and trade standards generally require framed walls to be plumb within 6 mm over 3000 mm (approximately 1:500 ratio). 12 mm in 2400 mm exceeds this (ratio of ~1:200), so the wall would need correction.

Question 4

What is engineered lumber (ELP/LVL) and what advantage does it offer over sawn lumber for long-span beams?

Accepted Answer

Laminated Veneer Lumber — consistent strength, no knots, available in longer lengths

Answer

LVL (Laminated Veneer Lumber) is manufactured by bonding thin wood veneers with structural adhesive. The manufacturing process eliminates knots and random defects, producing consistent, predictable strength in longer lengths than sawn lumber — ideal for headers, beams, and long-span applications.

Question 5

When installing wood I-joists, why must holes for mechanical runs be limited to the web area and not cut through the flanges?

Accepted Answer

The flanges carry bending stress — cutting them severely reduces the joist's load capacity

Answer

In an I-joist, the flanges carry the tensile and compressive bending stresses while the web resists shear. Cutting the flanges destroys the joist's bending capacity. Manufacturers specify hole size and location limits for web penetrations only.

Red Seal Carpenter 403A Practice Test

Red Seal Carpenter 403A Practice Test

403A Floor, Wall & Roof Framing 3