Practice Test Geeks(313D) Residential Air Conditioning Systems Mechanic Certification Practice Test
← All 313D Flashcard Decks

Regulations, Codes, and Safety Standards Flashcards

7 cards from real 313D practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Regulations, Codes, and Safety Standards flashcards as text

  1. Which section of the International Mechanical Code specifies the required access opening dimensions for HVAC equipment installed in attic spaces?

    Answer: IMC Section 306

    IMC Section 306 specifies access and service space requirements, including minimum opening sizes and clearances for equipment installed in attics, crawlspaces, and other confined areas.

  2. A technician discovers an unmarked refrigerant cylinder at a job site. According to EPA and DOT regulations, what must be done before the cylinder can be used or transported?

    Answer: The cylinder must be labeled, and unknown refrigerants must not be used or blended into known refrigerant supplies

    EPA and DOT regulations prohibit using unidentified refrigerants and require proper labeling; unknown cylinders must not be blended with known refrigerants to prevent contamination.

  3. Under current EPA rules, which types of refrigerants are classified as 'non-exempt substitutes' and may be subject to use restrictions under the SNAP program?

    Answer: Refrigerants listed as unacceptable or acceptable with use conditions for specific applications

    The EPA SNAP (Significant New Alternatives Policy) program evaluates substitutes and may list them as unacceptable or acceptable only under specific use conditions, restricting their application.

  4. What is the required minimum depth of a P-trap installed on a condensate drain line for an air handler with 0.5 inches of static pressure in the negative pressure section?

    Answer: 1 inch

    The trap depth must exceed the static pressure to prevent air bypass; for 0.5 inches of negative pressure, a minimum 1-inch trap depth is required to maintain the water seal.

  5. According to NEC Article 440, what is the maximum rating of a branch circuit overcurrent device (OCPD) for an air conditioning unit if the nameplate specifies 'Maximum Fuse or HACR Circuit Breaker – 30A'?

    Answer: 30 amperes

    NEC Article 440 requires that the OCPD not exceed the value marked on the equipment nameplate; if the nameplate states 30A maximum, the installed protective device must be 30A or less.

  6. Which federal agency enforces regulations under the Clean Air Act related to refrigerant handling and technician certification for stationary HVAC systems?

    Answer: EPA

    The EPA enforces Clean Air Act Section 608 regulations covering refrigerant handling practices, recovery requirements, and technician certification for stationary refrigeration and air conditioning equipment.

  7. What is the purpose of the 'nameplate data' requirement under UL 1995 for listed heating and cooling equipment?

    Answer: To give installers and inspectors essential safety and operating data required for proper installation

    UL 1995 requires nameplate data to convey critical installation and safety information — including voltage, ampacity, refrigerant type, and charge — so that installers and inspectors can verify code compliance.