310T Practical Skills and Training 3

Question 1

A technician is using an inductive clamp ammeter to measure parasitic drain on a truck. Where should the clamp be placed for an accurate reading?

Accepted Answer

Around only the negative battery cable

Answer

Placing the clamp around the negative cable measures total current draw from the battery with all other loads disconnected, giving an accurate parasitic drain reading.

Question 2

While diagnosing a no-start condition on a diesel engine, the technician finds cranking RPM is adequate but no injector pulses are detected. The NEXT logical step is to check:

Accepted Answer

Crankshaft and camshaft position sensor signals

Answer

The ECM requires valid crankshaft and camshaft position sensor signals to calculate injection timing and enable injector pulses.

Question 3

A multiplexed body controller on a coach is not responding to inputs. After confirming 12V power and ground are present, what should the technician check next?

Accepted Answer

CAN bus termination resistance (should be 60 ohms at the DLC)

Answer

A CAN bus with missing or open termination resistors will disrupt communication; the combined resistance at the DLC should read approximately 60 ohms for a properly terminated two-wire CAN.

Question 4

When using a diesel exhaust fluid (DEF) quality sensor scan tool reading, a value below the acceptable specific gravity range indicates:

Accepted Answer

DEF is diluted with water and SCR efficiency will drop

Answer

Low specific gravity means the urea concentration is below the required 32.5%, reducing SCR catalyst efficiency and potentially triggering derate conditions.

Question 5

A technician performs a cylinder contribution test on a diesel engine. Cylinder 4 shows no RPM drop when cut out. This MOST likely indicates:

Accepted Answer

Cylinder 4 is not contributing to engine output

Answer

No RPM change when a cylinder is disabled means that cylinder was already not contributing power, pointing to a misfiring cylinder due to a bad injector, low compression, or valve issue.

(310t) Truck and Coach Technician Certification Practice Test

(310t) Truck and Coach Technician Certification Practice Test

310T Practical Skills and Training 3