310S Steering and Suspension 4

Question 1

What is the purpose of the rebound stroke in a shock absorber?

Accepted Answer

To control the rate at which the suspension extends after compression, preventing the body from bouncing

Answer

Rebound damping controls the speed at which the suspension extends after being compressed by a bump. Without adequate rebound control, the spring would continue to oscillate, causing the vehicle to bounce repeatedly.

Question 2

A vehicle equipped with electronic stability control (ESC) has the ESC warning light on. The steering angle sensor was recently replaced. What must be performed?

Accepted Answer

A steering angle sensor calibration (zero-point learning)

Answer

After replacing the steering angle sensor, a calibration procedure must be performed so the ESC module knows the exact centre (straight-ahead) position. Without calibration, the system cannot accurately detect oversteer or understeer.

Question 3

What is the included angle in wheel alignment?

Accepted Answer

The sum of the camber angle and the steering axis inclination (SAI) angle

Answer

The included angle is calculated by adding the camber angle to the SAI angle. It is used as a diagnostic angle — if SAI is correct but the included angle is wrong, the steering knuckle is likely bent.

Question 4

What causes a memory steer condition (the vehicle pulls in whichever direction it was last turned)?

Accepted Answer

Binding in the steering column, upper strut mounts, or ball joints preventing the steering from returning to centre

Answer

Memory steer occurs when friction or binding in steering/suspension components (worn upper strut bearing plates, binding ball joints, or tight steering column joints) prevents the steering from freely returning to centre.

Question 5

What is the purpose of the air suspension system's ride height sensors?

Accepted Answer

To monitor vehicle height at each corner and signal the control module to adjust air spring pressure to maintain proper ride height

Answer

Ride height sensors (typically rotary position sensors on the suspension linkage) report vehicle height to the air suspension module, which adds or releases air from the springs to maintain the target ride height under varying loads.

Red Seal Auto Tech 310S Practice Test

Red Seal Auto Tech 310S Practice Test

310S Steering and Suspension 4