FREE Microsoft Windows 98 Questions and Answers
Up to ___ devices can be connected to the bus at once thanks to the tiered structure used by the USB.
Explanation:
The USB (Universal Serial Bus) uses a tiered star topology that allows up to 127 devices to be connected to the bus simultaneously. This is achieved through the use of hubs, which can be connected to other hubs, to expand the number of available USB ports on a system. However, the actual number of devices that can be connected to a single USB port is limited by the available power and bandwidth of the bus.
For use with HP JetDirect printers, which protocol should be chosen?
Explanation:
HP JetDirect printers typically use the TCP/IP protocol for network communication. When setting up the printer, you would typically select the "TCP/IP" option and enter the printer's IP address to configure the network settings.
How many different types of compression can you use with DriveSpace 3?
Explanation:
DriveSpace 3, the disk compression utility that came with Windows 98, supported three methods of compression: Lempel-Ziv (LZ), LZ with adaptive Huffman coding, and LZ with dynamic Huffman coding. It did not support four methods of compression.
DriveSpace3 guarantees a compression ratio of ____ by default.
Explanation:
DriveSpace 3, the disk compression utility that came with Windows 98, uses a compression ratio of 2:1. This means that it can typically compress files to half of their original size, freeing up disk space on the hard drive. However, the actual compression ratio can vary depending on the type of file being compressed.
Windows 98's minimal CPU specifications are as follows:
Explanation:
The minimum CPU requirements for Windows 98 are a 486 DX-66 MHz processor or higher. However, Microsoft recommended a Pentium processor and 16 MB of RAM for optimal performance.
How many steps are required to launch Windows 98 setup?
Explanation:
There might be some variations in the setup process depending on the specific installation media and hardware configuration, but the typical steps to start the setup process for Windows 98 are:
1. Insert the Windows 98 installation CD or floppy disks into your computer.
2. Restart your computer and boot from the installation media.
3. If booting from the CD, press any key when prompted to start the installation process.
4. Follow the on-screen instructions to configure your hardware, choose the installation location, and set up networking if desired.
5. You will be prompted to restart your computer when the installation is complete.
So five steps are involved in starting and completing the setup process for Windows 98.
The act of partitioning is called.
Explanation:
Partitioning is the process of dividing a hard disk into isolated sections, known as partitions or volumes. Each partition can be formatted with a file system and used to store data independently of other partitions on the same disk. This allows multiple operating systems to coexist on the same physical disk, or it can be used to separate system files from personal files to simplify backups or to organize data.